 |
Fragrance
Each Seda France candle is hand-poured and carefully crafted to provide you
many special moments. Any eventual irregularity in it is simply a confirmation
of its authenticity. We want you to enjoy the long-life of each candle and
suggest the following simple guidelines to ensure that enjoyment.
The first burn of your new candle is the most important and should be long
enough to create a melt pool that goes to the glass edge. Our candles are
designed to burn for 2-3 hours at a time which should be adequate for
achieving this desired melt pool. Our smaller occasion candles should burn
across in less time than the larger candles which may require at least 3 hours
for a complete burn pool. Any less time than this may cause the candles to
"tunnel" or burn down the center with too much wax unused. And burning for
periods longer than 2-3 hours will increase the intensity of the flame creating
excess carbon that may smoke. Our candles should not smoke if proper care
is taken of the wicks. We suggest trimming the wick to 1/4 inch before each
use, keeping the candle out of drafts, and again, limiting burning time to 2-3
hours. If at any time your candle wick starts to smoke, please review the
previous precautions; it may be necessary to extinguish the candle and trim
the wick again. Taking these simple steps will prolong the life of your candle
and allow you to enjoy it as intended.
If your candle is not allowed to burn long enough to melt the wax to the glass
edge and starts to tunnel, you can correct this by burning the candle longer
on the subsequent use. However, do not trim the wick when attempting this
type of correction and allow the candle to burn long enough to melt the entire
surface which may exceed the aforementioned 3 hours. Once the correction is
made you must always continue to follow the initial instructions regarding burn
times, wick length, etc.
All of our wicks are lead-free, and each of our fragrances is matched with the
best size wick that will insure the desired melt pool. You may notice a shiny
center in some of our wicks which is zinc oxide that creates stability in the wick
and allows it to stay centered as the wax melts. Not all of our wicks have this,
and as your candle burns, it may be necessary to re-center your wick to
maintain an optimum burn. Also, if you notice the flame throws too much in
one direction, it might be necessary to re-center your wick and/or adjust
toward the unmelted wax.
Finally, always place your candles on heat resistant level surfaces and out of
the reach of children. Keep your candles free of foreign objects and never
leave a lit candle unattended or in a draft.
many special moments. Any eventual irregularity in it is simply a confirmation
of its authenticity. We want you to enjoy the long-life of each candle and
suggest the following simple guidelines to ensure that enjoyment.
The first burn of your new candle is the most important and should be long
enough to create a melt pool that goes to the glass edge. Our candles are
designed to burn for 2-3 hours at a time which should be adequate for
achieving this desired melt pool. Our smaller occasion candles should burn
across in less time than the larger candles which may require at least 3 hours
for a complete burn pool. Any less time than this may cause the candles to
"tunnel" or burn down the center with too much wax unused. And burning for
periods longer than 2-3 hours will increase the intensity of the flame creating
excess carbon that may smoke. Our candles should not smoke if proper care
is taken of the wicks. We suggest trimming the wick to 1/4 inch before each
use, keeping the candle out of drafts, and again, limiting burning time to 2-3
hours. If at any time your candle wick starts to smoke, please review the
previous precautions; it may be necessary to extinguish the candle and trim
the wick again. Taking these simple steps will prolong the life of your candle
and allow you to enjoy it as intended.
If your candle is not allowed to burn long enough to melt the wax to the glass
edge and starts to tunnel, you can correct this by burning the candle longer
on the subsequent use. However, do not trim the wick when attempting this
type of correction and allow the candle to burn long enough to melt the entire
surface which may exceed the aforementioned 3 hours. Once the correction is
made you must always continue to follow the initial instructions regarding burn
times, wick length, etc.
All of our wicks are lead-free, and each of our fragrances is matched with the
best size wick that will insure the desired melt pool. You may notice a shiny
center in some of our wicks which is zinc oxide that creates stability in the wick
and allows it to stay centered as the wax melts. Not all of our wicks have this,
and as your candle burns, it may be necessary to re-center your wick to
maintain an optimum burn. Also, if you notice the flame throws too much in
one direction, it might be necessary to re-center your wick and/or adjust
toward the unmelted wax.
Finally, always place your candles on heat resistant level surfaces and out of
the reach of children. Keep your candles free of foreign objects and never
leave a lit candle unattended or in a draft.
| Burning Tips |
| Copyright © 2008 Makeup Lounge, Inc. ALL RIGHTS RESERVED. |
